FRON
T
LINKS
REAR LINKS
GROUNDSTACK
SPLAY LINK
GROUNDSTACK
FRONT LINK
STORAGE
LOCK
6°
4°
2°
0°
- 2°
- 4°
- 6°
C-AF CORA ARRAY FRAME -
Weight 27 kg
Engineered and manufactured in the UK
STORAGE
6°
4°
2°
0°
- 2°
- 4°
- 6°
6°
4°
2°
0°
- 2°
- 4°
- 6°
Manchester - England
Version 7.0 01/02/2019
16
4.4. CORA/CORA-A
CORA and CORA-A share the same physical size and rigging hardware.
Prepare the
fi
rst cabinets rigging hardware (as described in chapter 4.2. CORA Array
Rigging Mechanism). Lower the frame onto the cabinet until the front links line up
with the
fl
ying link holes on the frame and insert the locking pins of the frame on
each side. Using the data from Ohm’s pro-A-sync software rotate up the rear splay
links of the cabinet and align them with the correct pin points on the frame. Insert the
locking pins on each side of the frame.
Add further cabinets using the same procedure as above. Raise the frame with the
fi
rst cabinet attached and then lower onto the next cabinet and repeat the process.
Connect the speaker lines (CORA) or power and signal (CORA-A) according to the
number of ampli
fi
er channels and cabinets used.
Make sure to connect the cabling before the top of the array becomes out of reach.
Use the cable pick on the frame to choke and suspend the cabling without putting
any unwanted stress on the cabinets connectors.
Before hoisting the array to the desired trim height recheck the entire array including
its locking pins, splay angles, power and signal/speaker cabling. (Refer to chapter 5.
System safety checks).
Rear splay link
Pin B
Pin A
Pin C
Pin D
Rear splay hole
positions
Front top link
Hole position
Once prepared lower the frame until
the front top links of the cabinet are
able to slide into position.
If not already done, remove pin B from
rear splay link.
With the holes lined up lock in into
place using pin D from the frame.
Using thumb hole on rear splay link
rotate upwards ready to be positioned
on the rear splay link holes on the
frame.
1
3
2
4
