OHAUS GT 210, Directions For Use And Instructions For Installation

Page: 84 / 121

45
MENUS
1. Access the submenu.
2. .
3. or .
4. .
Type Approved/LFT Type Approved/LFT Type Approved/LFT Type Approved/LFT Type Approved/LFT
LFT can be set to ON or OFF. Selecting ON automatically sets the parameters shown
in the table to conform to type approved requirements. For sealing method, refer to
Type Approved Sealing section. Default setting are shown as follows:
Auto Zero .5 d
Lockswitch Menu Setup & Calibration
Stable Data Only Locked ON
Auto-Tare Locked OFF
Net/Gross Enabled
IMPORTANT NOTICE IMPORTANT NOTICE
IMPORTANT NOTICE IMPORTANT NOTICE IMPORTANT NOTICE
Unit Selection Unit Selection
Unit Selection Unit Selection Unit Selection
The Unit Selection (SEL) submenu per-
mits the selection of weighing units for use
during operation. The balance can display
weights in every unit of measure listed in
table. The default setting is shown in bold
type.
NOTE: NOTE: NOTE: NOTE: NOTE:
If Taels is enabled, see next page before
exiting the menu.
Weighing Units Weighing Units
Weighing Units Weighing Units Weighing Units
g g g g g Grams Grams Grams Grams Grams
dwt Pennyweight
ct Carats
oz Ounces
ozt Troy ounces
UNIT1 Grains
t Taels (see note)
UNIT2 Mommes
lb Pounds
UNIT3 Custom
United States Legal for Trade United States Legal for Trade United States Legal for Trade United States Legal for Trade United States Legal for Trade
All balances which contain the suffix "E" after the model number are
Type Approved/Legal for Trade. In accordance with the Marking
Requirements of Handbook 44, these products are designed for
use in the Net Weigh mode. Users who do not enable the Net Weigh
mode must attach the "RE-ZERO" label below switch marked "ON"
and ">O/T<". Refer to the Setup Menu, Net Weigh mode in this
Instruction Manual for directions on enabling Net Weigh mode.
For label location, see page 29.