OHAUS GT 210, Directions For Use And Instructions For Installation

Page: 102 / 121

63
MENUS
Stop Bits Stop Bits Stop Bits Stop Bits Stop Bits
The number of stop bits can be set to 1 or 2. The default setting is 2. To set stop bits,
proceed as follows:
1. Access the submenu.
2. .
3. or .
4. .
Good Laboratory Practice (GLP) Good Laboratory Practice (GLP) Good Laboratory Practice (GLP) Good Laboratory Practice (GLP) Good Laboratory Practice (GLP)
This submenu enables the storage of an identification number and/or a project
number. When entered into the balance, the identification number and project
number are available when printing. The reason the entries are made under the Print
submenu, is that when legal for trade operation (LFT) is enabled, the Setup submenu
is locked out, leaving the Print submenu free to make entries.
1. Access the submenu.
2. .
3. first digit is flashing.
4. changes the value of the first digit.
NOTE NOTE NOTE NOTE NOTE: allows going back to the previous digit for correction.
5. accepts value and moves to second digit.
6. to change next digit.
7. Repeat steps 4 through 6 to change all digits.
8. .
9. to enter project number.
10. and repeat steps 3 through 7.
11. .