OHAUS GT 210, Directions For Use And Instructions For Installation

Page: 90 / 121

51
MENUS
Good Laboratory Practices Good Laboratory Practices Good Laboratory Practices Good Laboratory Practices Good Laboratory Practices
Good Laboratory Practices (GLP) submenu allows the selection of Time, Balance
Identification Number, Identification Number, Project Number, Calibration and Name
data to be printed. The purpose of this submenu is to permit the printing of the above
selected items. These items are not displayed. The default setting is off.
When an external printer is used, and all items are set ON and the balance is
calibrated, the printer will print out calibration data for audit trail purposes and will
indicate date, and time. (It should be noted that the ID number and Project number
must be entered in the Print/GLP submenu before printed data is available). Since all
of the settings for the GLP submenu are done in a similiar manner, only one example
is shown.
1. Access the submenu under
SETUP
Options menu.
2. .
3. .
4. or .
5. .
6. Repeat steps above for Balance ID#, ID#, Project#, Calibration and Name.
Parts Counting Error Parts Counting Error Parts Counting Error Parts Counting Error Parts Counting Error
Parts counting Error is enabled only when the Parts Counting Function is selected.
The parts counting error level is the level of accuracy you consider acceptable for
parts counting results. The adjacent table lists error levels that you can choose from.
The default setting is shown in bold type.
EXAMPLE: With 5 Pct selected, 100 parts on the platform may yield a displayed count
from 95 to 105 parts.
To view, change or disable the PC Error Level:
1. Access the submenu under the Setup Option submenu.