OCULUS Easyfield C, Instruction Manual

Page: 20 / 64

7 Preliminary s tep s
16 / 60 Instruction Manual Easyfield® (GA/15000/XXXX/EN 1219 Rev01)
7 Preliminary s tep s
Before the initial operation of the Easyfield® you must first -

Install the software sec. 7.1, page 16

Set up the Easyfield® sec. 7.2, page 16

Connect the Easyfield® sec. 7.3, page 16

Ensure operational readiness, sec. 8.1, page 19

Set up firmware and drivers, sec. 7.4, page 19
Caution
Improper set-up may result in incorrect measurements or equipment
damage

Before you use the device for the first time, the Easyfield® must be
installed and connected by our service personnel or by an OCULUS-
authorized specialist.
7.1 In s tall the s oftware
If you are working with a PC or laptop, you must install the Easyfield®
software. The Easyfield® software consists of the following programs
which are installed together.

Patient Data Management

Easyfield® program

TNT program

Proceed as described in the Software Installation

After installing the software, restart the PC or laptop.
7.2 Set-up
The Operating Instructions are found in “Ambient operating
requirements” page 49 .

Remove the Easyfield® from the packaging.

Place the Easyfield® on a level surface.

Dispose of the packing material in a proper manner.
7.3 Connect
You must connect the Easyfield® to the power supply, and depending on
the configuration, to the netbook, the laptop or PC. Connection and set-
up will be demonstrated using the example of a netbook connection.