Oceanic OC1, Operating Manual, Page: 166 / 180

166
Fig. 171 - ORIENTATION
Battery
(+) ( - )
Fig. 172 - TMT O-RING
Transmitter Battery Removal
Locate the Battery cover on the end of the housing:
• Apply a coin to the recessed slot of the cover and turn it
counter clockwise out of the housing (Fig. 170).
• Remove the Battery from the and discard according to local
regulations governing disposal of Lithium batteries.
Transmitter Battery Installation
• Lightly lubricate the new Battery cover O-ring with silicone
grease and install it onto the cover. DO NOT roll it over
the threads, instead stretch it slightly to work it down over
the slotted end of the cover into the groove at the base of
the threads.
NOTE: The O-ring must be a genuine Oceanic
part available at an Authorized Oceanic Dealer.
Use of any other O-ring will void the warranty.
• Place a new 3 volt, CR2, Lithium Battery positive ( + ) side
into the Battery compartment with the negative ( - ) end
facing out (Fig. 171).
• Ensure that the Battery is properly oriented and the O-ring
is evenly seated around the Battery cover (Fig. 172).
• Carefully place the Battery cover with spring into the
housing and turn clockwise slowly by hand to ensure
proper threading.
Fig. 170 - COVER
REMOVAL