OCEANAIRE PWC Series Manual Download Page 5

Page: 5 / 32

STANDARD FEATURES

CABINET

The PWC-Series cabinet is constructed of 18 gauge steel with a gray

polyester powder coated finish that will compliment any decor. The entire cabinet is

insulated with sound- absorbing insulation for cool, quiet comfort. All units come

equipped with handles and swivel casters for portability and convenient set-up.

ELECTRONIC THERMOSTAT

All PWC units are equipped with a non-

programmable electronic thermostat. When power is connected to the unit, the thermo-

stat will control the unit to cool a space to the desired temperature. The thermostat is

also capable of controlling the fan to operate automatically (when needed) or continuous-

ly. To protect the compressor from short-cycling, there is a built-in time delay in the

thermostat. In the event of a power outage, all thermostat settings are saved, and the unit

will re-start automatically.

FAN SPEED CONTROL

A two position rocker switch, located near the thermostat,

provides the user with the option of running the evaporator fan at high-speed or

low-speed.

CONDENSATE PUMP

All PWC units come equipped with an Automatic Condensate

Pump that removes the condensate. The pump discharges through a check valve located

on top of the condensate pump assembly. The vinyl tubing exits through a 3/8” male flare

fitting, located in the recessed area of the unit. The pump has capabilities up to a 20’ lift,

to handle almost any installation requirement. If a failure occurs with the operation of

the pump circuit, the

NC overflow switch

will open, and the CONDENSATE ALARM warn-

ing light will energize. When the failure has been corrected, or the condensate line block-

age/kink has been resolved, the alarm light will clear, and the unit will restart.

CONDENSATE ALARM LIGHT

On the front of all PWC models, there is a Conden-

sate Alarm Light (RED) located near the thermostat. The light indicates a condensate
pump over-flow condition where the pump is either disabled, or incapable of removing
the condensate water, and must be serviced.

FILTERS

All PWC units are equipped with a washable filter at the air intake. An elec-

trostatic mesh air filter is located behind the evaporator return air grille to filter the air
before it is cooled, keeping the coil free from debris. The filter can be easily removed and
cleaned.

HIGH PRESSURE SAFETY SWITCH

Located near the hose fittings of the PWC

unit is a manual re-set high pressure switch, used for the protection of the compressor in

the event that the condenser water supply is turned off. If the condensing pressure

exceeds the limit setting, the switch cycles off the compressor, while the evaporator fan

continues to operate. Once the water interruption has been corrected, turn the unit off,

RESET THE RED BUTTON

by pushing down on the rubber boot in the recessed area of the

unit, listening for the click, and restart the unit.

POWER CORDS

All PWC units come with power cords, convenient connection and

portability. All models, except for the 3-phase and 5-ton units, are equipped with LCDI for