Using the ADC1000-USB: USB Mode
Configuring Data Acquisition
Select
Spectrum > Configure Data Acquisition
from the OOIBase32 menu bar to open the
Configure Data Acquisition screen.
From this screen, you can configure your data acquisition parameters such as integration time,
averaging, boxcar smoothing, and several other parameters.
Saving Wavelength Calibration Coefficients: USB Mode
You can store wavelength calibration coefficients unique to your S2000 Spectrometer on an
EEPROM memory chip on the ADC1000-USB. Once they are stored in memory, OOIBase32
reads the wavelength calibration coefficients. This feature is only available when using the
ADC1000-USB via the USB port.
Note
: If you are using the ADC1000-USB via the serial port, proceed to the
Saving Wavelength
Calibration Coefficients: Serial Mode
section.
Perform the following steps to save wavelength calibration coefficients using the USB mode:
1. Make sure that the S2000 Spectrometer and ADC1000-USB are connected to your PC.
2. Open OOIBase32 and select
Spectrometer > Configure
from the menu bar.
ADC1000-USB Operating Instructions
7
(Continued)
