Oce TDS600, User Manual

Page: 263 / 338

Maintenance 263
Maintenance of the reinforcement knives
Because the knives of the reinforcement unit get sticky from the glue on the
reinforcement tape, they have to be cleaned regularly. You are recommended
to clean the knives each time you have inserted a new tape roll (see ‘A new tape
roll’ on page 254) or when an error in the reinforcement unit has occurred.
If you want to clean the reinforcement knives, you have to place them in such
a position that all the parts that need to be cleaned are accessible.
Attention:
Only use the original Cleaner K and Fixing Unit Cleaning Oil
(silicon oil) from Océ, to avoid damage to the reinforcement unit.
▼ ▼ ▼ ▼
Clean the reinforcement knives
1
Press the on line button on the printer operating panel to put the printer off line.
The message ‘Off line’ is displayed in the status window.
2
Press the left selection button to shift the focus to the ‘Folding’ menu.
A shadow effect is used to indicate that the focus is set to this menu.
3
Select the ‘Clean knives’ option from the ‘Folding’ menu.
Then the reinforcement knives are placed in the correct position.
Note:
When a job is running, the message ‘Job interrupted’ appears. The
machine stops running after it has correctly finished the prints that were
already in the engine and the focus can be set to the Folding menu.
A picture of the engine appears on the display with the side door of the
reinforcement unit blinking.
4
Open the side door of the reinforcement unit.