![background image](http://html.mh-extra.com/html/oce/prismaproduction/prismaproduction_reference-manual_722613105.webp)
Messages
U20944-J-Z247-6-7600
However, if an installation is experiencing problems, PP/ROUTER should be run with
large user trace data sets at trace level 4. This trace level will impact the transmission
performance and place an I/O overhead on the system. GTF tracing is not recommended
because GTF suppresses records when trace activity is too high. The PP/ROUTER user
trace files will always contain all the trace records.
The use of the TRACETYPE and TRACESET options requires a knowledge of the
internals of SPS. These options are mainly to be used as requested by an Océ service
representative when special diagnostic traces are needed. Using the defaults for these
options will produce all information possible. This is the suggested mode when no special
request has been made by an Océ service representative.
The trace generation related parameters are TRACEFILE, TRACELEV, TRACESET and
TRACETYPE. For coding information please see the respective parameters under "Printer
Execution Parameters" in the
PRISMAproduction ROUTER Administrator's Guide
.
For all reproducible problems, in the absence of any special instructions from an Océ
service representative, the trace information should be:
At trace level 4
Directed to large user trace data sets or to tape (TRACEFILE(USER))
Run with options TRACETYPE(ALL) and TRACESET(FFFFFFFFFFFFFFFF) for these
parameters in the SETUPnnn member for the printer. These are the defaults when
TRACETYPE and TRACESET are not specified.
ITF Trace Tape Generation
Trace data generated to the PP/ROUTER trace data sets must be formatted into an ITF
6
trace tape for submission to Océ. This is accomplished by running the trace formatting job
FPTRACE supplied in SPS.SPSSAMP. The job can also be used to generate trace
reports on site by Océ service representatives.
A example job with the correct control cards for generating an ITF trace tape can be found
in Figure 23. The TROUT dd card should be adjusted to installation requirements and the
input trace data sets must be set to their correct names before running.
6
SPS ITF (Internal Trace Format) tapes have no relationship to the ITF (Internal Trace
Facility) delivered with Océ printers for hardware diagnostics from a PC.
Summary of Contents for PRISMAproduction
