Messages
U20944-J-Z247-6-7600
When the re-entrant portions of SPS are located in lpalib and default buffer allocations are
used, an installation should allocate 200K(800K) of virtual storage for each driver to be
run under a procedure. Using these estimates an installation using lpalib driving 2 printers
with one procedure and 1 printer with another procedure would require 400K(1.6M) in one
procedure and 200K(800K) in the other.
Libraries
SPS can be installed by using a steplib, linklib or lpalib. The simplest approach is to use a
steplib. When an installation has only one PP/ROUTER printer, this method will have little
performance impact on the system. The use of linklib instead of a steplib will reduce
search time and possibly load time.
If an installation requires more than one start-up procedure, it is desirable to place SPS in
lpalib to avoid multiple copies of SPS in the system (see "Memory" on page
Error!
Bookmark not defined.
). This approach also keeps search and load time to a minimum.
When all the SPS printers in the system can be driven by one procedure, little advantage
will be gained through the use of lpalib. Only search and load time will be reduced, real
memory requirements will remain the same.
Trace Files
If you need to run PP/ROUTER collecting trace data to the trace files and you are
experiencing poor transmission times, you may try to increase the number of buffers used
by the access method to write to the trace files. You may do that via the BUFNO
subparameter from the DCB parameter specified in both DD statements from the trace
files.
Summary of Contents for PRISMAproduction
