Maintenance
U20944-J-Z247-6-7600
If no checkpoints have been taken printing restarts from the first
page.
DATACK
Specifies what action is to be taken in the event of a data-check
error occurring.
There are two types of data-check errors; invalid-character errors
and print-position errors. Invalid-character errors occur when an
attempt is made to use a code point that is not assigned to a
character. Print-position errors occur when an attempt is made to
print outside the valid printable area. These errors also cause an
error message to be sent unless PIMSG=NO is also specified.
If error processing for an error type is BLOCK'ed the error is not
reported to SPS. This may cause a loss of output data.
If error processing for an error type is UNBLOCK'ed the error is
reported on the message page at the end of the print file in which it
occurs. See also the PIMSG parameter for related information.
BLOCK
specifies that no data-check error types should be reported to SPS.
UNBLOCK
specifies that all data-check error types should be reported to SPS.
BLKCHAR
specifies that invalid-character data errors will not be reported to
SPS.
BLKPOS
specifies that print-position errors will not be reported to SPS.
The default for this parameter is UNBLOCK. This parameter can be
also specified in the printer parameter phase (SPSZPARM), in the
control file, or in the DTF.
FORMDEF
Specifies the one to six character name of the form definition that
will be used in this print job.
Note:
The complete phase name in the library consists of a two-
character prefix (F1) followed by the name specified here. SPS
concatenates the two parts of the name for you.
PAGEDEF
Specifies the one to six character name of the page definition that
will be used for a line print job.
Note:
The complete phase name in the library consists of a two-
character prefix (P1) followed by the name specified here. SPS
concatenates the two parts of the name for you.
PRMODE
Specifies that the print job contains embedded EBCDIC shift-out
(SO) and shift-in (SI) controls used for switching between single-
byte and double-byte fonts. At least two fonts must be specified, the
Summary of Contents for PRISMAproduction
