![background image](http://html.mh-extra.com/html/oce/prismaproduction/prismaproduction_reference-manual_722613104.webp)
Messages
U20944-J-Z247-6-7600
If an ABEND has resulted in a dump, the dump should be sent on tape.
When to Dump
SPS will always take a diagnostic dump for any conditions in which it would be useful.
Even when SPS is cancelled by the operator due to a wait or loop condition, no
dump should be requested
. The SPS ESTAE routine will receive control from the cancel
command and take a user 222 dump. If a dump is requested by the operator, a second
dump will be taken by the operating system.
In all situations where SPS is capable of recovering from an error and a dump would be
useful for diagnostic purposes, SPS takes a dump unless the DUMP(NO) option in the
SETUPnnn member for the ROUTER printer has been selected. This option is generally
not recommended. In the event of an error while running with the DUMP(NO) option, the
option should be changed to YES and SPS reinitialized. Then the problem should be
recreated, so a dump is available to the Océ service representative.
If one SPS printer is hanging and you have other printers running under the same
procedure, you should cancel the hanging printer via the F SPSx,PRTx,CANCEL
command. See the
SPS Administrator's Guide
for more information.
When to Trace
The SPS internal trace facility is one of the most useful tools for diagnosing system or
SPS internal problems. The product should always be run with trace level 3 for testing,
maintenance, installation, and trace level 0 for normal production. For all reproducible
problems, trace data should be collected in the trace data sets at trace level
4. The trace specification may be dynamically changed via SPS commands (close and
open the trace files, change the trace level and set). See the
SPS Administrator's Guide
for more information.
Trace Generation
The suggested normal running mode for PP/ROUTER is trace level 0 and no trace data
sets (TRACEFILE(NO) in SETUPnnn). This will produce a flow trace of reasonable size in
an abend dump with very little system overhead and no impact on transmission time.
Summary of Contents for PRISMAproduction
