Oce CS6407, Quick Reference Manual

Page: 10 / 206

10
17
Enter the remaining media.
Enter the remaining roll media loaded on the printer.
S E T R E M A I N I N G M E D I A
* X X X m
Note
- After installing the media, check whether the media on the
platen has no fl oat or wrinkles.
18
This sign is displayed when the slack is
insuffi
cient.
-
In case of use of sheet media, this message is not
displayed.
- If the media slackness is insuffi cient, the next
operation will not be started.
C H E C K
S L A C K E N M E D I A
19
Press the tension bar to the peel roller’s upper
part. Then create a slack between the platen
and the peel roller, by carrying the tension
bar to the rear side of the peel roller with a
supply-side feed switch.
Switch
Tension bar
Tension bar
Adjust the tension bar length and decide whether to
attach a fl ange or not, depending on the type and
width of the media.
Examples of tension bar combinations
Size used Tension bar length
L 48 inches (123 cm)
L, S 64 inches (164 cm)
L, S, S 80 inches (204 cm)
<General media in TENSION winding mode>
Put a tension bar suitable for the media width.
Usually put a tension bar suitable for the media width with a
few exceptions.
<General media without take-up reel unit>
Put a tension bar which is half the width of the media.
<Vinyl chloride media>
Put an S size tension bar (without a fl ange) on the center of
the slack.
Peel roller
Scroller fl ange
Supply-side slack sensor
S S
r
Slacken off to a level lower than the supply-side slack sensor.
When the slack reaches the sensor detection area, the
operation panel blips.
Note
- Be sure to rotate the panel with the supply-side feed switch.
Do not rotate the peel roller manually, or the printer may be
damaged.
20
Check the media setting.
Press the key.
S E T M E D I A
* O K ?
P R E P A R I N G M E D I A
P L E A S E W A I T
Note
- Rewind the printer's media completely at the end of the day. The
PVC media installed and left for a night on the printer may cause
media jam.