Oce CS6407, Quick Reference Manual

Page: 31 / 206

31
ENGLISH
ADJUST MENU
Menu Outline of functions
#TEST PRINTS
>NOZZLE PRINT
Used to print the adjustment pattern that is used for mechanical and electrical adjustments.
#PH TO PH VAL
#YYY >+00 Used to adjust the head position (print position in the lateral direction of media) of the main scanning
direction of each print head. Enter the correction value based on the print result of [PH TO PH].
#PH R/L ADJ VAL
#YYY >+00 Used to adjust the right and left nozzle spotting positions of each print head. Enter the value where
the vertical lines of each color align based on the print result of the right and left adjustment pattern.
#BIDIR ADJ L XXXXXX
#YYY >+00
Used to adjust the shuttle position of the set media. Enter the correction value based on the print
result of [BIDIR ADJ PRINT1 to 4].
#EDGE SENSOR ADJ VAL
>+0.0mm Used to adjust for correct position of image to be printed on the media. Enter the correction value
based on the print result of [EDGE SENSOR ADJ PRINT].
SETUP MENU
Menu Outline of functions
#LANGUAGE
>JAPANESE
Select the language of messages used for LCD.
#TIME ZONE (GMT+)
>YY/MM/DD HH:MM ZZZ
Select a time zone.
#LENGTH UNITS
>MILLIMETER
Select a length unit.
#TEMPERATURE UNITS
>CENTIGRADE
Select a temperature unit.
#BEEP(UNCAP CARRI)
>ON Set whether to emit a warning beep in the state below.
- The print head is dislocated from the cap in the daily maintenance or head height adjustment.
- The print head cannot be capped due to a media jam error during printing.
#BEEP(TUR TIMEOUT)
>ON
Set whether to emit a warning beep when a take-up (TUR) timeout has occurred.
#BEEP(INK ERROR)
>ON
Set whether to emit a warning beep when an ink error has occurred.
#BOOT VERSION
*X.XX
Displays the BOOT version.
#PRINTER FW VER
*X.XX_YY
Displays the system fi rmware version.
#MAIN PCA VER
*XXXXX
Displays the version of the IPB board.
#ACT PCA VER
*X.XX
Displays the version of the ACT board.
#CARRIAGE PCA VER
*XXXXX
Displays the version of the HCB board.
#BTC VER
*XXX
Displays the version of BTC (FPGA).
#USB ADDRESS
*XXX
Displays the USB address.
#USB SPEED
*HIGH-SPEED
Displays the transfer speed of USB connection.
#FACTORY DEFAULT
>
Sets all parameters to the initial settings at factory shipping.
#PRINTER FW UPGRADE
>
Sets the printer to the online update mode.
#DOWNLOAD
>
Sets the printer to the download mode.
#JAM SENSITIVITY
>HIGH(DEFAULT)
HEATER MENU
Menu Outline of functions
#HEATER STANDBY TIME
>30 min Select the time to maintain the standby set temperature of the heater (including the time for
transition to the standby set temperature) after printing.