Identifikationssystem OBID
®
Montageanleitung ID ZK.AB-A
FEIG ELECTRONIC GmbH
M00500.0de-ID-B.DOC
Seite 42 von 52
4.6 How to program a second “Masterkarte“
In order to guarantee ultimate safety, the factory “Masterkarte“ may only be programmed
by FEIG ELECTRONIC GmbH and should therefore be kept in a safe place.
Apart from the factory „Masterkarte“, an additional transponder may be authorized as
2
nd
“Masterkarte“. For this procedure, you will need the enclosed factory “Masterkarte“.
Bring the factory
“Masterkarte“ into
the antenna field and
leave it there until the
“
M“
appears on the
display.
)DF
WRU\
0DV
WHUND
UWH
l
After the memory
address 190
(9.0)
l
an
“
M“
1
will apear
on the display.
Remove the factory
“Masterkarte“ from
the antenna field.
)D
FW
RU
\
0
DV
WH
UND
UWH
l
The display lights up
continuously for
approx. 3 s
l
After that, the
display flashes for
about 6s
Bring the transpon-
der, which is to be
used as the 2
nd
“Masterkarte“, into
the detection area.
1HZ
7UDQ
VSRQ
GHU
l
The new transpon-
der is now program-
med as a 2
nd
“Masterkarte” and
the right decimal
point lights up.
The 2
nd
“Masterkarte“ may
now be removed.
The programming
process has been
completed
0
DV
WH
UND
UWH
l
The
display
goes
out.
Notice:
A transponder, which has already been stored as identification card, may not be used as a
2
nd
“Masterkarte“. In this case, the display will skip to the respective storage location.
1
only if factory “Masterkarte“ is used