![OBH Nordica IMMERSION SOUS VIDE PRO 15L Instruction Manual Download Page 46](http://html.mh-extra.com/html/obh-nordica/immersion-sous-vide-pro-15l/immersion-sous-vide-pro-15l_instruction-manual_721547046.webp)
• Be sure to have clean hands and only use clean kitchen tools.
• Ensure that you have fresh, high quality ingredients.
• Only use fresh, well cleaned vegetables and herbs.
• Use separate kitchen tools for different ingredients. You must keep raw
food and its kitchen tools separate from cooked food.
• Always prepare the food properly; see the recommendations in the table
further down the directions.
• Serve the cooked food immediately or follow routines for safe storage and
cooling.
Before use
Attach the sous video appliance to the pot/container so that the fastening
screw is located on the outside of the container. Note that the water must
reach the indicated MIN level. In addition, a container of at least 5 litres with
a diameter of at least 24 cm and a height of at least 22 cm is recommended.
The sous vide appliance has a maximum capacity of 15 litres for heating water.
After the water has been added, gently shake the appliance to remove any air
bubbles from the water pump. Remaining air bubbles may otherwise cause the
appliance to be very noise and unnecessary wear to the pump. Then screw the
Sous video appliance onto the container using the fastening screw.
NOTE! The appliance must be screwed onto a container and may not be
placed freely. Note that it must also be placed completely straight in the
container
Start by seasoning and vacuum packing the ingredients to be cooked so that
everything is prepared before the appliance is started. Follow the instructions in
the manual for the vacuum packer before vacuum packing.
Fill the pot/container with water above the MIN mark on the circulator,
otherwise the appliance will not start and the display shows ”E1”. Note that
the water level should be between the MIN and MAX markings when the
vacuum-packed produce is soaked in the water. Warm tap water can be used
to shorten the heating time.
Place the pot/container on a flat and moisture resistant surface (preferably
on a trivet) and plug the appliance into a wall outlet. A beep be heard and the
display will flash, showing 88:88. Start the appliance by pressing the power/
start/pause button on the display for about 2 seconds, the display will show
the presets 56°C and 08:00.
The appliance is preset for temperature display in °C. If display in °F is desired,
press the temperature/time selector button (6) for about 3 seconds to switch
between the temperature units. Note that this must be done before starting the
appliance.
Press the time/temperature setting button (6), the display will flash and the
desired temperature can now be set depending on what to cook (see table
below) using the + and - buttons. The temperature range is 25-90°C.
46
7974_SB_0418.indd 46
2018-05-25 11:22:49
Summary of Contents for IMMERSION SOUS VIDE PRO 15L
