Q-Code User Manual
Ver. 7.0 2021/11/30
82
Users can switch the pins to “Input Pin” or “Output Pin” by clicking the Direction column. Clicking other
columns can also select more related setting.
After clicking OK to return to the main window as shown below, the I/O pin configuration is completed.
Ex.
PA.0, PA.3 as input pin, PA.1, PA.2 as output pin.
PA.0 =
[
Direction:
Input
, InputType:
Pull-High
, Trigger:
Low
]
PA.1 =
[
Direction:
Output
, Current:
Normal
, Initial:
Low
, Busy:
High
]
PA.2 =
[
Direction:
Output
, Current:
Normal
, Initial:
Low
, Busy:
High
]
PA.3 =
[
Direction:
Input
, InputType:
Pull-High
, Trigger:
Low
]
Input_Resistor =
Strong
Matrix Key setting
Click “Matrix” in the I/O section and click +/- buttons on the popped out window to configure “Matrix”.
Click the Available Pins buttons to set pins. The actual operation is shown in the following figure:
1. Click to switch the pins to Input / Output.
4. Complete.
2. Click to select the input mode.
3. Click to select the
output mode.