NW Global Vending Festival, Installation - Use - Maintenance

Page: 42 / 60

© by N&W GLOBAL VENDING S.p.A.
36
03-2012 3775 00
Chapter 3
MAINTENANCE
The installation and the subsequent maintenance
operations shall be carried out with the machine con-
nected to the power supply and therefore by specialised
personnel, trained for the use of the machine, who has
been informed of the specific risks deriving from such a
situation.
To supply power to the entire machine with the open door,
it's enough to insert the appropriate key in the general
switch.
Supplying power to the machine when the window
is open activates the lighting.
D
o Not starE DirEctly iNto ligHt sourcEs
Inside the machine, only those parts which are
protected by covers and which are highlighted with
a label "disconnect voltage before removing the
cover" remain live.
Before removing these covers, it's necessary to
unplug the machine from the net.
The integrity of the machine and compliance of the
corresponding systems with the regulations shall
be verified, at least once a year, by qualified per -
sonnel.
MAINTENANCE AND CLEANING
The machine always has to be kept clean, inside and
outside.
Cleaning can be done with commercial products as long as
they're not too aggressive.
When cleaning half disks in a dishwasher, water tempera-
ture must remain lower than 60°C.
Cleaning products can leave unpleasant odours
inside the machine if not properly removed.
To grant a perfect pick up doors operation, doors must
be kept clean.
Do not grease or oil in ANY case!
IMPORTANT
You must avoid contact between the disks and oil/
grease!
Condenser must be kept clean using a vacuum cleaner,
a brush, etc.
PRODUCTS DISKS ASSEMBLY AND
DISASSEMBLY.
After opening the two quick connector, it is possible to
remove the two half disks.
- Disks must be rotated using loading buttons, until separa-
tion line and closure hub are visible
- Insert the dedicated key on the closure hub and open
quick connector with a slight left rotation (clockwise)
- Keep rotating the disk for 180° and open next closure hub
- Keep rotating for other 90°
- Extract first disk half where the jog wheel is fitted
- Keep rotating for other 180° and extract the second half of
the disks where the jog wheel is fitted
- Put everything back together, following the inverted
procedure.
Only disks with identical section division (see fig. 15) can be
grouped.
1
2
3
4
5
6
7
2
1
1
Fig. 19
1- Half disks
2- Quick connect