Nussbaum SPL 10 Series, Owner'S Manual

Page: 31 / 32

TWO POST SPL10000
Nussbaum Automotive Solutions, LP | 1932 Jordache Court, Gastonia, NC 28052 | 704.864.2470 | Email: info@nussbaum-usa.com | us.nussbaumlifts.com
31
Regular security check after installation
C
omplete and leave in Serial No:……………….
this manual
Type of Check In order Error Verification Remark
Serial # and Model # Decal …………………………….
Operating Instructions Decal …………………………….
Warning Decal …………………………….
Main Switch (if applicable) …………………………….
Function of limit switch …………………………….
Overhead shutoff function …………………………….
Condition of the arm adapters …………………………….
Condition of the rubber support pads …………………………….
Function of the joints/stages of arms …………………………….
Manufacturing (deformation/ cracking) …………………………….
Engagement of nyloc nuts (ca
cables) …………………………….
Function of the safety locks …………………………….
Condition of the equalization cables ……………………………
Condition of Pulleys …………………………….
Condition of the cylinder covers …………………………….
Condition of the hydraulic hoses/tubes …………………………….
Oil level …………………………….
Sealing of the hydraulic system …………………………….
Surface of the piston-rod …………………………….
Condition of the electrical wires, ground …………………………….
Test: lift with vehicle …………………………….
Condition of the concrete floor (cracks) …………………………….
(mark where applicable, in case of verification mark in addition to the first mark!)
security check carried out: ........................................................................................................................................
Name, address of the competent................................................................................................................................
Result of the Check:
Initiation not permitted, verification necessary
Initiation possible, repair failures until .............................................................................
No failings, Initiation possible
Signature of the expert: ................................. Signature of the operator: ..............................
If failures must be repaired
Failures repaired at: ...................................... Signature of the operator: ..............................
(Use another form for verification!)