TWO POST SPL10000
Nussbaum Automotive Solutions, LP | 1932 Jordache Court, Gastonia, NC 28052 | 704.864.2470 | Email:
| us.nussbaumlifts.com
19
INSTALLATION AND INITIATION
SAFETY CHECKS
The safety check is necessary to guarantee safe operation of the Lift during use.
Safety checks should occur as follows: after installation, before initial startup, after initial startup, at least once a year,
and any time modifications have been made to the Lift.
Before the installation of the Lift, secure the installation area to
prevent access by unauthorized persons. It is recommended to use
a crane, forklift, or scissor Lift and supports to maneuver the Lift
and to avoid accidents.
PREPARE LIFT ASSEMBLY LOCATION
The installation of the Lift is performed by manufacturer trained technicians or
by the manufacturer’s distribution partner. The Lift owner may use their
trained mechanics to install the Lift. The installation must be performed
according to the following regulations:
•
Use architectural plans, if available, to determine Lift location.
•
Lift is intended for indoor installation only. Installation in an outdoor
application is prohibited and will void the warranties of the product.
•
Always consult a qualified person regarding local regulations for seismic
requirements.
•
Do not install Lift in hazardous locations, pit or depression areas, or
washing stalls.
•
Install Lift in a bay with at least 144 inches of overhead clearance for
SPL10000 and 162 inches of overhead clearance for the SPL10000XL.
•
Concrete must have compression strength of at least 3,500PSI and be a
minimum of 4 inches thick.
•
Mount on a level foundation.
•
Mount on a foundation deeper than the local external frost line.
•
Be sure to read the ANSI/ALI ALIS prior to installation.
Summary of Contents for SPL 10 Series
Page 1: ......
