Nussbaum JUMBO NT 3500, Operating Instruction And Documentation

Page: 30 / 48

Operating Instruction and Documentation
Jumbo NT 3500
- 30
-
Damage to external surfaces, must be immediately repaired.
If theses repairs are not made immediately, permanent damage to the
powder-coated surface may result.
Repair and clean damaged areas with an abrasive paper (grain 120).
After this is complete, use a suitable paint (observe the RAL Number).
Check the zinc surface and repair it with a suitable tool. Use abrasive
paper (grain 280).
Check the zinc surface and repair it with a suitable tool. Use abrasive
paper (grain 280).
White rust can result from moisture laying in certain areas for long
periods of time. Poor aerating can also result in rust formation.
Rust may result from mechanical damage, wear, aggressive sediments
(de-icing salt, liquids) or insufficient cleaning.
Repair and clean these areas with abrasive paper (grain 280).
After this is complete, use a suitable paint (observe the RAL Number).
minimum once in a
year
Check the electrical parts, cables on damage.
Optional: CE-Stop switch
Press buttons, main switch
Electrical cables
During installation and maintenance always checked the condition of
the switches and cables. Every cables must be secured that they not
touched moveable parts or they are not crushed.
minimum once in a
year
Check the condition of the polymer supports. If necessary replace it. if necessary
Check the condition and function of the ramps
minimum once in a
year
Check the condition of the concrete. (cracks)
minimum once in a
year
Check the torque moments of the dowels (see the page “record of
installation)
minimum once in a
year
Check the torque moments of the screws.
minimum once in a
year