Nussbaum JUMBO NT 3500, Operating Instruction And Documentation

Page: 36 / 48

Operating Instruction and Documentation
Jumbo NT 3500
- 36
-
• Press the button ”lowering“ shortly until both locking device (pic) are falling downwards
(e.g. 1-2 cm).
• Now close the equalisation screws A1 & A2.
• Raise the lift ton the top height. The locking device is unlocked. It is possible to move the
must be move with the hand in this position
• The lift has now the normal function..
9.5 Initiation
Before the initiation a security check must be performed. Therefore use form: First
security check.
If the lift is installed by a competent person, he will perform this security check. If the
operator installs the lift by himself, he has to instruct a competent person to perform the
security check.
The competent confirms the faultless function of the lift in the installation record and form for
the security check and allows the lift to be used.
Please send the filled installation record to the manufacturer after installation.
9.6 Changing the installation place
If the place of installation shall be changed, the new place has to be prepared in according to
the regulations of the first installation. The changing should be performed in accordance with
the following points:
• Raise the lift on approx. 1000 mm
• Remove the covers of the hydraulic tube.
• Loose the dowels.
• Lower the lift in the lowest position
• If necessary loose the hydraulic hoses only on the operating unit.
• Disconnect the power supply
• Install the lift in accordance with chapter 9 “ Installation and Initiation”
Use new dowels, the used dowels can not be used anymore.
A security check must be performed before initiation by a competent person. Use form
“Regular security check”.