Nussbaum JUMBO NT 3500, Operating Instruction And Documentation

Page: 32 / 48

Operating Instruction and Documentation
Jumbo NT 3500
- 32
-
parts) an extraordinary security check must be performed by an expert.
This manual contains form with a schedule for the security checks. Please us the adequate form
for the security checks. The form should remain in this manual after they have been filled out. In
the following there is a short description about special safety devices.
9. Installation and Initiation
pic.8:
9.1 Installation of the automotive lift
You can choose between two installation places of the operating unit: The position of the
operating unit is in drive-in direction right or in drive-in direction left.
9.2 Regulations for the installation
• The installation of the lift is performed by trained technicians of the manufacturer or its
distribution partner. If the operator can provide trained mechanics, he can install the lift by
himself. The installation has to be done according to this regulation.
• The standard lift must not be installed in hazardous locations or washing areas.
• Before installation a sufficient foundation must be proved or constructed.
• An even installation place has to be provided. The foundations must be based in a frost
resistance depth, both outside and indoors, where you must reckon with frost.
• An electrical supply 3~/N+PE, 400 V, 50 Hz has to be provided. The supply line must be
protected with 16 Ampere time (VDE0100 German regulation). The minimum diameter
amounts to 2,5 mm².
• All cable ducts have to be equipped with protective coverings to prevent accidents.
9.3 Erection and doweling of the lift
Before installing the lift, it must be done everything to exclude accidents .
• Carefully remove the lift from its wooden crate. Check the lift for damage.
• Install the lift according to the data sheet and the foundation diagram drawing.
• Install the operating unit at its designed place and connect the power supply.
• Fill in hydraulic oil, approx. (see chapter 3.). A high quality hydraulic oil is recommended, its
viscosity should be 32 cst. The level of the oil is between of upper marking and the lower
marking of the oil level gauge.