Nussbaum 2.60 HL SST, Operating Instruction And Documentation, Page: 23 / 58

Operating Instruction and Documentation
2.60 HL SST
- 23 -
o) Raise and lower the automotive lift a few times without load. Observe the process.
p) Mount the covers.
7.Inspection and Maintenance
Before conducting maintenance work, preparations must be made to ensure that
during maintenance and repair work there is no risk to the safety of people
working on or around the lift and also that there is no risk of damage to equipment
being used on or around the lift.
To guarantee the utmost availability and to ensure that the lift remains functional, maintenance
work contracts are organised between our clients and their local retailers.
A service must be performed at regular intervals of 3 months through the operator in
accordance with following service manual. If the lift is in continuous operation or in a dirty
environment, the maintenance rate must be increased.
During daily operation the lift must be closely observed to ensure that it is functioning correctly.
In the case of malfunction or leakage the technical service must be informed.
7.1 Maintenance plan of the lift
Before beginning any maintenance work isolate the power supply. Secure the main
switch (lock it). Secure the danger area around the automotive lift and secure the lift
against unintentional lowering.
Maintenance plan
Period
Check the condition of the type plate, the short operating instruction
and the sticker “capacity. min. 1x yearly
In case of heavy dirt deposit clean the piston rods of the hydraulic
cylinders from deposit. Remove the cover of the lift. If necessary raise
the lift to the highest position.
Grease the piston rods with a high capacity lipid (approx. 5 g of S2
DIN51503 KE2G of the Renolit Company. min. 1x yearly
Clean and check the moving parts. Lubricate the moving parts of the lift
(hinge bolts, rolls, sliding surfaces).
Grease with a multipurpose lipid (example: Auto Top 2000 LTD. Agip).
min. 1x yearly
Check the sliding block of the lifting carriage. In case of wear or
damages exchange it. Grease it with a multipurpose fat. min. 1x yearly
Grease the lubricating nipples of the double joint arms with a
multipurpose fat. min. 1x yearly
Check the hydraulic tubes/hoses for leakage.
Check the screw fittings. min. 1x yearly
Check the oil level. Fill in a clean, high quality oil (32 cst) in the tank. min. 1x yearly
The hydraulic oil has to be changed at least once a year. To change
the oil, lower the lift into the lowest position. Empty the tank and
replaced clean oil, approx. 21 litres are needed. A high quality hydraulic
oil is recommended, its should be 32 cst. (e.g. HLP 32 LTD. OEST
Company) min. 1x yearly