Nussbaum 2.60 HL SST, Operating Instruction And Documentation

Page: 19 / 58

Operating Instruction and Documentation
2.60 HL SST
- 19 -
Problem: the lift does not lower!
Potential causes:
An obstacle is restricting the lift from being lowered
Hydraulic valve is defective
Fuse is defective
The SST is locked
Button “lowering” is defective
solution:
(see chapter 6.1)
Call technical service
Check the fuse
Call technical service
Call technical service
Problem: the arms do not move
Potential causes:
The unlocking button is defective
Not enough air pressure
Air hose defective
solution:
check the button
check the air pressure
check the air hose
6.1 Lowering onto an obstacle
If the Safety-Star-System recognizes a difference of 40 mm between both lifting carriages it
automatically switches off the lift.
6.1.1 Remove an obstacle
Only trained and authorized staff are allowed to work with the DIP-switches! The
main-switch must be switched off!
• Remove the cover of the control box.
• Press the button “Reset” (1) and hold it. (see Pic. 5, “Reset Achskontroller 1”)
pic 5: Platine - Controller
LED (A) switches off in case
of malfunction
LED (B) switches off in case of
malfunction in the measure
systems. (redundant: examine the
measuring systems)
LED blinks to the rhythm of
1 sec under normal
operational function
Pos. 3
Reset
„controller
“
Pos. 1
Reset
„Monitoring controller
PIC“
Pos. 2
DIP-switches
LED switches off in case the
voltage of the processor is
under 5Volt