38
WAAS G-III Reference Receiver User Manual Rev 1
Chapter 4
Commands
4.1.2
Determining the Current Command Settings
To determine the current G-III Reference Receiver command settings, request a
RXCOMMANDSB
log
(described in
Section 5.5.16 RXCOMMANDSB
on
Page 121
).
RXCOMMANDSB
provides a listing of all
commands and parameter settings. This log provides the most complete information on receiver configuration.
For some commands, such as
LOG
, multiple parameter sets can exist. For example, you can use the
LOG
command with one set of parameters to enable logging of the
SATPOSB
log. You can use it again with a second
set of parameters to configure the G-III Reference Receiver to output the
CARDSTATUSB
log. When the
LOG
command is entered the second time, the new parameter set does not overwrite the first, it exists in addition to
the first set.
THRESHOLD
L1ca 36 20 36
L1c 36 20 10
L2c 36 20 10
L2py 30 10 10
L5gps 36 20 36
L1geo 36 26 36 18
L1geo 36 26 36 19
L1geo 36 26 36 20
L1geo 36 26 36 21
L1geo 36 26 36 22
L1geo 36 26 36 23
L1geo 36 26 36 24
L1geo 36 26 36 25
L5geo 36 26 36 26
L5geo 36 26 36 27
L5geo 36 26 36 28
L5geo 36 26 36 29
L5geo 36 26 36 30
L5geo 36 26 36 31
L5geo 36 26 36 32
L5geo 36 26 36 33
Table 14: Factory Defaults for Commands (continued)
Command
Parameters
