WAAS GUS Signal Generator User Guide Rev 1
9
Notices
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Changes or modifications to this equipment not expressly approved by NovAtel Inc. could result in violation of
FCC and CE Marking rules and void the user’s authority to operate this equipment.
Where applicable, follow the electrical codes for the country of installation. Examples of country codes include:
•
USA
National Electrical Code (NFPA 70)
•
Canada
Canadian Electrical Code (CSA C22)
•
UK
British Standards Institute (BSI 7671)
To maintain compliance with the limits of a Class A digital device, you must use properly
shielded interface cables when using the serial ports. Appropriate cables include Belden #9539,
or equivalent, and Belden #8770 cable for input power source (ensuring the shield is connected
to the protection ground).
CAUTION:
Double pole/neutral fusing
CAUTION:
The WAAS GUS Signal Generator must be installed in a Restricted Access Location only.
Except for the externally accessible AC Fuses located on the rear panel, the WAAS GUS Signal
Generator is not user-serviceable. In the event of any failure of the unit, do NOT remove any
cards or covering panels from the unit. Return the unit to the factory for repair.
