Operation Description
34
through the tilling width regulator. Front and rear relative
position for the left and right suspension points can be
changed by lowering the plow width regulator.
The working width will then be increased when the right
suspension point moves forward; otherwise the tilling
width will be decreased. You can adjust the device for the
furrow width to ensure the plow frame is aligned, which
will help to avoid repeating or missed furrowing.
IMPORTANT ISSUES
1.
When plowing, never adjust the traction of the farm machinery by adjusting the limit rod. Instead, reduce the
number of bottoms (plowshares) to match the tractor’s pulling capacity. This will help you avoid damaging
the suspension mechanism.
2.
In order to avoid damage to the implement suspension mechanism when plowing, the tractor should never be
turned without lifting the farm implement it is towing.
2.16.7 Sway Bar Adjustment
The sway bars are mainly used to prevent impact on the rear wheels of the tractor caused by an overlarge swing of
the lower tie rod when the tractor turns around at the end of a field with a lifted farm implement in tow. When the
farm implements are in the plowing position, the sway bars are in a loose state. Therefore, a certain amount of
swing between the tractor and the farm implement is allowed.
NOTE
：
1.
When moving the tractor and an attached implement over long distances, the height of the implement
should be adjusted to its lowest level by using the adjustable 3 -point arm. The adjustable limit rod
should also be used to keep the machinery from swingin g to the right or left during transport.
2.
The nuts for the adjustable 3-point arm and the limit rod should also be tightened to prevent wide
swings of the implement during transport.
