36
SmartCraft gateways
Installation and Operation Manual
NAVMAN
Appendix A - Specifications
Physical
Size 130 x 62 x 26 mm (5.1 x 2.4 x 1.0 in).
Operating temperature 0 to 50°C (32 to
122°F).
Built-in cable to the Navman instrument, 1 m
(3.3 ft) long.
Built-in cable to SmartCraft and engine, 300
mm (1 ft) long.
Electrical
Power supply 9.0 to 30 V DC, 50 mA.
Interfaces
NavBus connection to Navman instruments.
CAN bus connection to SmartCraft system.
Standards compliance
EMC compliance
USA
(FCC): Part 15 Class B.
Europe
(CE): EN50081-1,EN50082-1,
EN55024, EN55022, ISO7637-1.
New Zealand and Australia
(C Tick) : AS-NZS
3548.
Cable to Navman instrument
Wire
Signal
Red
Power positive, 9 to 30 V DC,
50 mA
Black
Power negative
Brown
Power positive from instrument
Orange
Blue
NavBus -
Green
No connection
Yellow
No connection
White
No Connection
Appendix B - Troubleshooting
1 No SmartCraft functions available or
SmartCraft data is zero or is not displayed
a Boat engine key is off.
b Review installation; check the gateway LEDs
are working (see section 2)
c SmartCraft is disabled in the Navman Instru-
ment. See Setup > System menu.
2 Some SmartCraft data is not available:
The data available depends on engine type
(see section 1-1).
3 Can not start troll control:
a Some MerCruiser engines do not support troll
control.
b Set engine to idle and in gear (see section
Troll Control).
c Set
Speed type
to
Paddle
(see section
Troll Control).
d To use speed troll control, the Navman instru-
ment must have a Navman paddlewheel
speed sensor connected.
4 Trim window is slow to appear, or appears
when trim does not change:
Change the trim filter (see sectionTrim Setup
and Calibration).