Page1
1. Safety information
The tester is intended for use in compliance with the local rules for electrical usage. Avoid using in
places which may be inapplicable for the use of electronics such as hospital, gas station etc.
◆
To prevent operational failure, the product should not be exposed to moisture.
◆
It is highly recommended to avoid violent collision or heavy vibration to the tester during
transportation and use, heavy vibrations or collisions can damage the tester.
◆
The tester
should not be charged for more than an 8 hour period
. If the battery is found severely
hot, the tester should be removed from the electric source at once.
◆
Do not use the tester where the humidity is high. If the tester becomes wet or damp, power off
immediately and disconnect cables.
◆
The tester should not be used in the environment with the flammable gas.
◆
Do not disassemble the tester, there are no user serviceable parts inside.
◆
The tester should not be used in an environment with strong electromagnetic interference.
◆
Do not use heavy detergents to clean the LCD screen. If dirt is not easy to remove, then the unit
should be powered down and cleaned with a soft, dampened cloth. Only a small amount water and
neutral detergent can be used.
2. IP Camera Tester Introduction
2.1
General
The 3.5 inch touch screen IP camera tester is designed for maintenance and installation of IP, HD-TVI
and Standard Analog cameras. The tester supports both ONVIF PTZ and analog PTZ control and UTC
control (TVI camera dependant). The combination of touch screen and key buttons make the IP camera
tester very user friendly.
Built in PING & IP address searching functions can diagnose the location of the network cable’s short
circuit and open circuit. Test LAN cable or telephone cables and the sequence of wires. Its portable,
user-friendly design and multi-functions make the IP camera tester an essential tool for the installer or
