Page12
3. Operation
3.1
Installing the Battery
The tester has built-in lithium ion polymer rechargeable battery. Open the hatch on the back of the
tester, connect the battery cable to the tester cable (make sure the red and black wires on the
battery cable match those on the tester cable) The battery cable inside battery cabin should be
disconnected if the tester will not be used for a long period of time.
Pressing the key continuously can power on or off the tester.
Notice
：
Please use the original adaptor and connected cable of the device!
When the battery icon is full or the charge indicator turns off automatically, indicate the battery
charging is completed
When the Charge Indicator
turns off, the battery is approximately 90%
charged. The charging time can be extended for about 1 hour and the charging time within 12
hours will not damage the battery.
Notice
：
Press the key several seconds to restore the default settings when the
Instrument works abnormally.
3.2
Instrument connection
3.2.1
IP camera connection
Power the IP camera by outer power source, then connect the IP camera to the IPC tester’s LAN port, if
the link indicator of the tester’s LAN port is green and the data indicator flickers, it means the IP
camera and the IPC tester are well connected. If the two indicators do not work, check if the IP camera
is powered on or the network cable is ok.
