Page19
A.
Protocol
Click on the protocol box to enter a list of protocols, drag the list up or down then click on the desired
protocol. The left and right arrows can also be used to scroll through the protocol menu. move the
Supports more than thirty PTZ protocols. Such as Pelco-D, Samsung, Yaan, LiLin, CSR600, Panasonic,
Sony, etc.
B. Port
Click the “port” button to select the communication port for the PTZ camera controlling (only RS485 is
available on the tester)
C.
Baud
Click the “Baud” button to select the baud rate according to baud rate of the PTZ camera.
(150/300/600/1200/2400/4800/9600/19200/57600/115200)
D. Address
Set the ID according the ID of PTZ camera (0~254), the setting address data must be consistent the
speed dome address.
E. Pan speed: Set
the pan speed of PTZ camera (0~63)
F. Tilt speed:
Set the tilt speed of PTZ camera (0~63)
G. Set preset position (Set PS)
Click and select “Set PS”, set and save
preset position number (1~128),
H. Call the preset position (Go ps)
Click and select “Set PS”, set and save
preset position number (1~128), click “sure” to save,
Call be used to call some special preset numbers
,
can also call the dome camera menu
Protocols, address, interface and baud rate must all be consistent with the dome camera in order for the
IPC tester to work.properly. After setting the parameter, the tester can control the PTZ and lens
To control PTZ by screen touch:
Tap left, right, up or down on the touch screen to control the PTZ rotation direction. Using two fingers
pinch inward or spread outward on the touch screen to zoom in and out the PTZ.