North&Wing&S,LSA&Maintenance&Manual&
Model:&Sport&X2&582&
Issue 3.2
Printed: July 16 2017
Page 57
Task Description:
1.
!
Remove wheel as described in Section 4.3.3 above.
2.
!
It is NOT necessary to separate the rim halves.
3.
!
Using a long drift pin, reach in from one side and tap the bearing out of its seat by
tapping around the circumference of the outer bearing race.
4.
!
Turn the tire over and tap the bearing on the other side out.
5.
!
Align new bearings in their seats and gently tap them in with a rubber or wooden
mallet or block of wood. Be careful not to drive them hard when they are not aligned
with the seat.
6.
!
Remount wheel and wheel pants.
4.3.5
&
Replace Rear Brake Pads, Calipers, and Disc, and Bleed Brakes
Skill Level:
LSR-M, A&P
Tools:
1-1/8” Socket,
¼
” Hex (Allen) key , 1/8” ignition box wrench, clean pump type
oil can or syringe for brake fluid injection.
Materials:
Replacement brake pads, ATF fluid, 12” x 1/8” rubber or neoprene tubing
Task Description:
1.
!
Remove wheel as described in Section 4.3.3 above.
2.
!
If the brake caliper is being replaced, disconnect the hydraulic brake line from the rear
of the caliper. Catch and discard any brake fluid that drains from the lines. DO NOT
attempt to re-use the brake fluid. If the caliper is not being replaced or serviced, leave
the brake lines attached.
Hydraulic Brake Line
Bleed tap