Nortel Optical Multiservice Edge 6130, Planning Manual, Page: 192 / 292

10-6 Appendix A: Data communications planning
Optical Multiservice Edge 6130 NT6Q92MA Rel 1.0 Iss 1 Standard September 2006
For more information on the detail procedures, refer to Provisioning and
Protection Switching Procedures , 323-1855-310.
AGRE
(see Note 4 )
<Up> • Layer2 Protocol=GRE • Layer3
Protocol=IP
• MTU=446 bytes
No No
SGRE-1
(see Note 5 )
<Up/Down> • Layer2 Protocol=GRE
• Remote MAA=<490000>
• Remote SID=<000000000000>
• NSAP Selector Byte=<2F>
• Layer3
Protocol=IP
• MTU=<446> bytes
Yes No
Note 1:
It is recommended to leave the Eth0 network interface port in Admin Up state.
Note 2: OSPF and iISIS cannot be simultaneously enabled for a network interface.
Note 3:
E1/VC12 management communication between OME6130 and OME6110 (Release 1, Release
2.0, Release 2.01 software) should use Layer 2 Protocol as Standard PPP, RFC1661.
Note 4: The Auto GRE tunnel is automatically created when iISIS is enabled at the nodal level on the
NE. The AGRE network interface parameters are not user-provisionable.
Note 5: The Static GRE tunnel can only be created if iISIS is enabled at the nodal level.
Table 10-4
Dynamic routing protocol parameters
Routing
Protocol Status Provisionable parameters Network Interface
support
OSPF <Enable /
Disable> • Hello Interval=<10>
• Router Dead Interval=<40>
• OSPF Authentication Mode=
<Disable authentication /
Simple password>
• Password/Key=<>
• eth0
• mgmt1, mgmt2
• ecc_x_x
• SGRE-x
iISIS
(see Note 1 )
<Enable /
Disable> • L1 Default Metric=<4>
• L2 Default Metric =<4>
• L2 Routing Only=<Disable /
Enable>
• ecc_x_x
Note 1:
In this release, the L2 Default Metric and L2 Routing Only parameters are not
supported for iISIS routing protocol.
Table 10-3
Network interface provisionable parameters summary
Network
interface Admin
Status Layer 2 parameters Layer 3
parameters OSPF
support iISIS
support