Page 90 of 150
Installation and configuration
P0914209
Standard 3.00
April 2000
Note: ESAM configuration values are stored on the RMI. If the user
replaces the RMI for any reason, all values set with the SET ESAM
command, and all commands on the ESAM setup menu, must be
reconfigured.
Figure 35
SET ESAM (S E) screen
1
System Parameters
- This variation of the
SET ESAM
command
configures the number of digits in the ESAM directory number for each
channel and the trunk access digit, or the number dialed by the user to
obtain an outside line. Its display is similar to Figure 36.
Figure 36
SET ESAM:SYSTEM PARAMETERS screen
MCR::>s e
ESAM Setup Menu:
1 - System Parameters
2 - Show Slot Parameters
3 - Set Slot Parameters
4 - Phone Parameters
5 - XUT Parameters
6 - Trunk Parameters
8 - Quit (No Save)
9 - End (Save)
MCR::>S E
ESAM Setup Menu:
1 - System Parameters
2 - Show Slot Parameters
3 - Set Slot Parameters
4 - Phone Parameters
5 - XUT Parameters
6 - Trunk Parameters
8 - Quit (No Save)
9 - End (Save)
1
DN Size (2-5) [Current Value - 4]
Trunk Access Digit (0-9) [Current Value - 9]
ESAM Setup Menu:
MCR::>
