Digital Telephone IP Adapter Installation and Administration Guide
75
June 2005
Configuring the IP Adapter unit using the telephone menu
manually enter
static IP
information for
this Digital
Telephone IP
Adapter
unit,
(continued)
7 Press
2
, below, to leave the Digital
Telephone IP Adapter
unit’s IP gateway as it is.Press
1
to modify the Digital Telephone IP Adapter
unit’s
IP gateway.
8 Press the
Hold
key.
Result:
The telephone display prompts you for the
Digital Telephone IP Adapter unit’s new, permanent
IP gateway. The telephone display also shows the
current setting, similar to the following:
Enter IP Gateway
0.0.0.0
9 Press the digits of the Digital Telephone IP Adapter
unit’s permanent IP gateway. Use the
*
key for the
IP address delimiter. (Refer to the table on page 61.)
10Press the
Hold
key.
Result:
The telephone display asks if you want to
enable DiffServ, similar to the following:
Enable DiffServ?
[1-Yes 2-No]
Note:
The Remote Gateway 9100 Series family of
products does not support Classless Inter-Domain
Routing (CIDR).
enable prioritizing
of voice packets in
the IP header
(DiffServ),
1 Press
1
.
2 Press the
Hold
key.
3 Proceed to “Enable 802.1Q Mapping? [1-Yes 2-
Note:
Refer to the
Reach Line Card Installation and
Administration Guide
for information on DiffServ
CodePoint and 802.1Q Mapping.
IF you want to
THEN do the following:
