Nortel CallPilot 150, Installation And Maintenance Manual

Page: 76 / 94

76 Modem Access
P0990474 0
3
Configuring the Dial-Up Networking TCP/IP parameters on Windows 2000
1
Right click on the Dial-Up Networking connection you created for CallPilot and then click
Properties.
2
Click the Configure button.
3 Select the Enable hardware flow control option.
4
Clear the following options:
Enable modem error control
Enable modem compression
Show Terminal window
Run script options
5 Click the OK button.
6
Click the Security tab.
7 Select the Advanced (custom settings) option.
8
Click the Settings button.
9 Select the Allow these protocols option.
10
Select the Unencrypted password (PAP) option and clear the other options.
11 Click the OK button.
12
Click the Networking tab.
13 In the Type of dial-up server I am calling drop list, click PPP:Windows 95/98/NT4/2000,
Internet.
14 Click the Settings button.
15
Select the following options:
Enable LCP extensions
Enable software compression
Negotiate multi-link for single link connections
16
Click the OK button.
17 Select the Internet Protocol (TCP/IP) option.
18
Click the Internet Protocol (TCP/IP) heading and then click the Properties button.
19 Select the Use the following IP address option.
20
Enter the IP address of CallPilot system, but change the last set of digits to a different number.
For example, if the CallPilot IP address is 192.168.0.1, enter 192.168.0.10.
21
Click the OK button.
22 Click the OK button.
Note: The IP address you enter here is used to identify your computer during the
modem connection. It does not affect the LAN configuration of your computer.