Nortel CallPilot 150, Installation And Maintenance Manual

Page: 74 / 94

74 Modem Access
P0990474 0
3
Configuring the Dial-Up Networking TCP/IP parameters on Windows NT 4.0
1
Click the Configure button.
2 Click the Initial speed drop list and then click 115200.
3
Select the Enable hardware flow control option.
4 Clear the following options:
Enable modem error control
Enable modem compression
5
Click the OK button.
6 Click the Server tab.
7
Click the Dial-Up server type drop list, and then click the PPP:Internet, Windows 95/98/
NT4 option.
8
Select the following options:
TCP/IP
Enable software compression
Enable PPP LPC extensions
9
Click the TCP/IP Settings button.
10 Select the Use the following IP address option.
11
Enter the IP address of CallPilot system, but change the last set of digits to a different number.
For example, if the CallPilot IP address is 192.168.0.1, enter 192.168.0.10.
12
Clear the following options:
Use IP header compression
Use default gateway on remote network
13 Click the OK button.
14
Click the Security tab.
15 Select the Accept any authentication including clear text option.
16
Click the OK button.
If you want to access the Dial-Up Networking TCP/IP parameters to check or edit the settings, use
the following procedure
1
Click the Start button and then click Programs.
2 Click Accessories and then click Dial-Up Networking.
The Dial-Up Networking dialog box appears.
3 Click the More button and then click Edit Entry and modem properties.
Note: The IP address you enter here is used to identify your computer during the
modem connection. It does not affect the LAN configuration of your computer.