![Nortel CallPilot 150 Installation And Maintenance Manual Download Page 59](http://html1.mh-extra.com/html/nortel/callpilot-150/callpilot-150_installation-and-maintenance-manual_1707091059.webp)
59
CallPilot Mini/CallPilot 150 Installation and Maintenance Guide
Chapter 9
Upgrading CallPilot Mini/CallPilot 150
This section describes how to upgrade the CallPilot Mini/CallPilot 150. You can upgrade:
•
the CallPilot software
•
the message storage
Upgrading the CallPilot software version
Make sure that there is no one using the CallPilot Mini/CallPilot 150 before you start the upgrade.
For information about how to determine if the CallPilot ports are busy, refer to
“Programming
CallPilot 150 DNs to memory buttons” on page 84
.
1
Nortel Networks recommends that you backup your CallPilot information before you upgrade
the CallPilot software. For information about how to backup CallPilot, refer to
“Backing up
the CallPilot information” on page 53
.
2
Put on an anti-static strap and connect it to a grounded metal object.
3
Unplug the power connector from the CallPilot Mini/CallPilot 150.
4
Insert the upgrade cartridge in the top PCMCIA slot.
For the location of the PCMCIA slots, refer to
Figure 1 on page 19
.
5
Restore power to the unit.
The CallPilot Mini/CallPilot 150 starts up. During the start up, the LEDs turn on and off in the
following sequence:
•
LEDs 1 to 4 light for approximately 20 seconds
•
LEDs 1 to 4 turn off for approximately 25 seconds
6
The CallPilot Mini/CallPilot 150 copies the files from the upgrade cartridge to the feature
cartridge. During the upgrade, the LEDs turn on and off in the following sequence:
•
LEDs 1 to 4 cycle on and off, one at a time, for approximately 8 to 10 minutes
•
LEDs 1 to 4 turn off for approximately 40 seconds
•
some or all of the LEDs 1 to 4 may light to indicate TCM connections to the CallPilot
on these ports
Caution:
The upgrade cartridge must be inserted in the top PCMCIA slot.
If the upgrade cartridge is inserted in the bottom PCMCIA slot, your current software
overwrites the upgrade cartridge and all of your programming is lost. Contact your
Nortel Networks Service Representative for assistance.
Caution:
Never install the upgrade cartridge or the feature cartridge in any device
other than the CallPilot Mini/CallPilot 150. These cartridges can be corrupted by
inserting them in other devices.
Summary of Contents for CallPilot 150
