Nortel CallPilot 1005r, Hardware Installation

Page: 24 / 74

1005r server description Standard 1.06
24 CallPilot
Valid PCI card configurations
Introduction
There are six PCI card slots; three low-profile and three full-size. Valid
configurations of low-profile and full-size cards are shown in the table
“1005r PCI card slot configurations” on page 25 .
Note: Your server configuration depends on what was ordered from
Nortel. Therefore, your server may not have all of the slots populated.
When looking at the server from the rear (see “Back panel controls and
features” on page 19 ), both full-size and low-profile cards are numbered
from the top down.
ATTENTION
You must connect the DS30X-1 cable to an MGate card to
receive the clock source for the MPB96 board. Failure to
connect the DS30X-1 cable to an MGate card can result in
noise interference on the remaining voice channels.