Nortel CallPilot 1005r, Hardware Installation

Page: 49 / 74

December 2006 Installing the server and peripheral devices
1005r Server Hardware Installation 49
3 Connect one end of the USB cable into the modem.
4 Connect the other end of the USB cable into either USB port 1 on
the rear panel (long term) or USB port 2 on the front panel (short
term).
5 Ensure that a single-point ground reference is available for all the
power outlets serving the CallPilot server and its peripherals. Before
the CallPilot server installation, a qualified electrician must
implement the single-point ground reference requirement between
the power outlets of the CallPilot server and the power outlets of the
switch.
To connect the external SCSI tape drive
1 Set the SCSI ID dial switch on the tape drive to SCSI ID 6.
2 With the power switch off, connect the external SCSI tape drive to
the port labeled N on the rear panel. See
“Rear panel connectors”
on page 47 .
3 Plug the tape drive into the same single-point ground and A/C
power as the rest of the system.
4 Power on the tape unit.