Nortel 2000, Using Manual

Page: 362 / 405

362 Appendix C Media dependent adapters
208700-B
.
To install a GBIC:
1
Remove the GBIC from its protective packaging.
2
Insert the GBIC into the Host port on the MDA ( Figure 138 ).
GBICs are keyed to prevent improper insertion. If the GBIC resists pressure,
do not force it. Remove it, turn it over, and reinsert it.
Figure 138 Installing a GBIC
3 Press on the front of the GBIC until it snaps into place
.
4
Remove the rubber plug to connect cables.
Removing an Installed GBIC
To remove an installed GBIC:
1 If the GBIC has spring tabs, press in on the tabs on each side of the GBIC as
you pull the GBIC out of the MDA’s Host port (
Figure 139 ).
Note: The MDAs are not hot-swappable. Power down the switch before
installing or removing an MDA.
9825FA