Nortel 2000, Using Manual

Page: 83 / 405

Chapter 1 The Business Policy Switch 2000 83
Using the Business Policy Switch 2000 Version 1.2
SNMP trap support
The Business Policy Switch supports an SNMP agent with industry-standard
SNMPv1 traps, as well as private SNMPv1 trap extensions (
Table 6 ).
For information on configuring SNMP using the CI menus, refer to Chapter 3,
Using Web-based Management for the Business Policy Switch 2000 Software
Version 1.2, Reference for the Business Policy Switch 2000, Command Line
Interface Software Version 1.2, and Reference for the Business Policy Switch 2000
Management Software Version 1.2.
Supported standards and RFCs
This section lists the standards and RFCs supported by the BPS 2000.
Table 6 Supported SNMP traps
Trap name Configurable Sent when
RFC 1215 (industry standard):
linkUp Per port A port’s link state changes to up.
linkDown Per port A port’s link state changes to down.
authenticationFailure System wide There is an SNMP authentication failure.
coldStart Always on The system is powered on.
warmStart Always on The system restarts due to a management
reset.
s5CtrMIB (Nortel proprietary traps):
s5CtrUnitUp Always on A unit is added to an operational stack.
s5CtrUnitDown Always on A unit is removed from an operational stack.
s5CtrHotSwap Always on A unit is hot-swapped in an operational
stack.
s5CtrProblem Always on An assigned base unit fails.
s5EtrSbsMacAccessViolation Always on A MAC address violation is detected.