Powder Pilot
™ HD
P/No.7192721_02
Page | 36
Spectrum HD MANUAL CONTROL SECTION
Pushing the button
on the Spectrum HD control screen will display controls for manual
operation of various devices of the feed centre.
Note:
the operator takes full responsibility of his actions on the system.
All automatic functions of the Spectrum
HD
are inactive while on that screen.
Exit screen
1 2 3 4 5 6 7 8 9
1
–
Dump valve
–
This button is used to open / close the dump valve in the bottom of the hopper.
2
–
Virgin HDLV transfer pump on/off
–
This button is used to start or stop the virgin pump.
3
–
Main duct damper
–
used to open or close the damper inside the main extraction duct behind the
feed centre.
Note:
when this duct is closed, the full extraction goes to the purge duct on top of the sieve.
4
–
Recycle HDLV transfer pump on/off
–
This button is used to start or stop the reclaim pump located
at the cyclone or a custom recycling system.
5
–
Vibrator motor on / off
–
this button starts or stops the vibratory motor installed into the virgin powder
box support.
6
–
Purge duct damper
–
used to open or close the damper inside the purge duct on top of the sieve.
7
–
ultra-sonic sieve on/off
–
this button starts or stops the ultra-sonic sieve.
8
–
main air solenoid
–
this button opens or closes the main air solenoid in the supply line to the feed
centre.
9
–
Hopper fluidisation on / off
–
this button starts or stops fluidising the powder inside the hopper
