Applicators
29
P/N 317091G
E
2011 Nordson Corporation
EP11 / EP 12
Nozzle Filter
Changing Filter Cartridge
NOTE:
Remove filter cartridge only when the nozzle filter is hot and not
under pressure. Install only when nozzle filter is hot.
WARNING:
Hot! Risk of burns. Wear heat‐protective gloves.
WARNING:
System and material pressurized. Relieve system of pressure
before replacing filter cartridge. Failure to observe can result in serious
burns.
Refer to page
,
Relieve pressure.
Removing Filter Cartridge
1. Place a container under the filter bore.
For filter cartridges with air relief valve go to step 3.
2. Insert screw into center tapped hole (Fig. 14).
Fig. 14
3. Unscrew the filter cartridge counterclockwise with an open‐end wrench or
CAUTION:
As soon as the thread is disengaged, cease turning.
Otherwise part of the filter cartridge may remain in the bore.
Fig. 15
4. Use suitable pliers to carefully extract filter cartridge (Fig. 16).
5. Purge the filter bore by allowing the pump to run briefly with material. This
rinses out particles of dirt that may still be in the filter bore.
6. Properly dispose of material according to local regulations.
Fig. 16
