1
2
3
Applicators
13
P/N 317091G
E
2011 Nordson Corporation
EP11 / EP 12
Connecting Heated Hose
WARNING:
Hot! Risk of burns. Wear heat‐protective gloves.
Using Second Open‐end Wrench
Use a second open‐end wrench when connecting and disconnecting the
heated hose. This prevents the unit's hose connection from turning.
Fig. 5
Connecting
If cold material can be found in the hose connection, these components (1, 2)
must be heated until the material softens (approx. 80
_
C, 176
_
F).
1. First connect the hose (3) electrically to the unit.
2. Heat the system and hose to approx. 80
_
C (176
_
F).
3. Screw on heated hose.
Fig. 6
Disconnecting
WARNING:
System and material pressurized. Relieve system pressure
before disconnecting heated hoses. Failure to observe can result in serious
burns.
WARNING:
Hot! Risk of burns. Wear safety goggles and heat‐protective
gloves.
1. Set the motor speed of the melter to 0 rpm; switch off motor(s).
2. Place a container under the nozzle(s) of the applicator / assembly
handgun.
3. Activate the solenoid valve(s) electrically or manually; or pull the trigger of
the assembly handgun. Repeat this procedure until no more material
flows out.
4. Properly dispose of material according to local regulations.
