Reface
Applicators
25
P/N 317091G
E
2011 Nordson Corporation
EP11 / EP 12
Assembling Nozzle
1. Apply high-temperature grease (Refer to page
Processing Materials
).
S
To the O‐rings
S
To the screw threads
S
Under the screw heads.
2. Use pins to join mouthpiece receptacle (7), shim plate (5) and
mouthpiece (4), then screw together. Do this by hammering in the
alignment pins (6) until the tops of the pins are even with the top of the
mouthpiece.
3. Put Quadrings (1) back into place if necessary.
4. Screw application nozzle back onto the body with the fixing screws (8).
NOTE:
Tighten fixing screws size M4, property class 70 in three steps, with
a total of 2.5 Nm. Use a torque wrench.
NOTE:
Contact Nordson for information on special models with different
screws.
Inserting New Shim Plate
1. Disassemble the application nozzle. Refer to page
2. Fit new shim plate between mouthpiece and mouthpiece receptacle. The
shim plate is held in place by two cylinder pins.
3. Screw nozzle halves together.
NOTE:
The shim plate protrudes 1 to 2 mm out of the nozzle.
4. The shim plate must be ground until it is even with the mouthpiece and
the mouthpiece receptacle.
5. Assemble the nozzle. See instructions above.
Fig. 10
