NORDFOREST 46-113, Operating Manual

Page: 52 / 240

52 46-113, 46-114 | 11.2018
Commissioning and operation
8 t wood splitter
›
Before changing location, always disconnect the mains plug from
socket for the wood splitter.
›
Tilt the wood splitter back slightly until the wheels are on the
ground.
It is now possible to roll the wood splitter.
Commissioning and operation
WARNING
Danger due to splitting column falling!
Serious injuries are possible.
›
Never reach into the splitting area when the splitting column is
moving.
›
Always check the two-hand operation before use.
›
Before starting up the wood splitter, open the filling screw on the oil
tank roughly a 3/4 turn.
This allows the hydraulic system to independently vent without
difficulty during work.
The control valve is set in the manufacturer’s factory. Further settings
are not necessary.
ATTENTION
Danger due to work at low temperatures!
The oil in the hydraulic system is very viscous at low temperatures.
Starting work (splitting) immediately at low temperatures can lead to
damage to the hydraulic system.
›
Run the wood splitter without a load at low temperatures for
a short time first, so that the hydraulic oil can heat up.