Nordcap 402729447, Installation And Operating Manual

Page: 60 / 65

Glass door models
• turn off the main switch and disconnect the plug;
•
remove the upper cover;
• arrange a support (not supplied) for placing at the bottom
part of the door;
• undo the screws “H“, remove the foot and lower bracket “E“;
• screw in the foot, remove the temporary support and turn
the door 180°;
• remove spiral bushing “F“, move pin “L“ from the slotted
hole on the left to that on the right. Fit spiral bushing “F“ on it,
turned 180°;
• unscrew the left foot, position lower bracket “E“ and screw
on the bracket and foot.
• remove upper bracket “G“;
• refit the door on the lower left hinge;
• refit bracket “G“ on the left side of the cabinet;
• adjust the door, ensuring perfect adherence of the magnetic
seal and refit the top cover.
IMPORTANT
Reversing the opening of glass doors is possible
only
on single module positive temperature
versions.
G NORMAL MACHINE USE
WARNING
Refer to “ Warning and Safety
Information “.
G.1 Characteristics of personnel trained for
normal machine use
The Customer must make sure the personnel for normal
machine use are adequately trained and skilled in their duties,
as well as ensuring their own safety and that of other persons.
The Customer must make sure his personnel have understood
the instructions received and in particular those regarding work
hygiene and safety in use of the machine.
G.2 Characteristics of personnel enabled to
operate on the machine
The Customer is responsible for ensuring that persons
assigned to the various duties:
• read and understand the manual;
• receive adequate training and instruction for their duties in
order to perform them safely;
• receive specific training for correct machine use.
G.3 Operator qualified for normal machine
use
Must have at least:
• knowledge of the technology and specific experience in
operating the machine;
• adequate general basic education and technical knowledge
for reading and understanding the contents of the manual,
including correct interpretation of the drawings, signs and
pictograms;
• sufficient technical knowledge for safely performing his
duties as specified in the manual;
• knowledge of the regulations on work hygiene and safety.
In case of a significant anomaly (e. g. short circuits, wires
coming out of the terminal block, motor breakdowns, worn
electrical cable sheathing, etc.) the operator for normal
machine use must:
• immediately deactivate the machine.
E
H
I
G
F
F
L
E
H
G
F
F
L
27